12
MOTOR MOUNT ADAPTER
● If desired, the staking tool can
be mounted to a motor for
production stake cutting.
● We offer an adapter that allows the tool to
fit over a motor shaft. The Motor Shaft
Adapter is available for purchase on our
website or by phone.
● Remove the shank that comes pre-installed to the
tool by using a pipe wrench
● Screw the adapter into the tool where the shank
was removed
● Slide the tool with the adapter over the motor
shaft and secure in place by tightening the set
screws (Make sure the key is in place)
● NEVER exceed more than 1750 RPM when
operating the tool.
● Make sure a key is included
with the motor shaft
● If there is no key the
adapter will not properly
hold.
TIP
To Next Page
Loading...