11
WRONG
Drill not in-line with stock (crooked)
CORRECT
Drill in-line with stock
● Make sure the tool is square against the end of the log
before cutting
● If the tool is held at an angle the stake will be cut angled
4.5
CUTTING STAKES (CONT.)
Remember to always use a vise or clamp to hold your material.
RECOMMENDED MOTOR SPECS
Horsepower
● ½HP to 2HP
RPM
● 500 to 1750
Voltage
● 115
Hertz
● 60
Shaft Diameter
● 5/8 in
Shaft Design
● Keyed
WARNING: Never hold onto material being cut with bare
hands under and circumstances!
To Next Page