10
ALWAYS unplug the drill before adjusting
the blades or adjusting the chuck!
CUTTING STAKES(CONT.)
● Carefully install the staking tool into an unplugged 1/2” drill, and
tighten it firmly by using the chuck key
● With the tool installed, square up to the log/stock so that the cutting
face is flush with the end of the log/stock
●
Apply body pressure by leaning against the back of the drill.
● Wait until the drill comes to a complete top before removing the
cutter from the log/stock.
Pull tool back once
drill has stopped
Maintain
constant
pressure
● Pull the trigger to cut a stake. Continue applying body pressure as
the tool cuts.
TIP
The staking tool will continue to cut even after the log is pointed.
Stop the drill immediately after the point is cut to avoid wasting material.
To Next Page
Loading...