9
CUTTING STAKES
WARNING: If the stock comes loose or unclamped while cutting the stake,
DO NOT drop the drill or try to grab the stock! Stop cutting and remove the
tool from the end of the log. Re-secure the log, and resume cutting.
● Obtain the stock you want to point
● Make sure the diameter fits the tool
● Cut it to length and make sure the ends
are flat. If the ends are not even/flat, the
point will be crooked.
● If the diameter is larger
than the tool can accept,
taper the end with a
hatchet or draw knife.
● Secure the stock in a vise, clamp,
or fixture with a “V” shaped
notch
● The Lumberjack Tools Log Lock
is a safe, easy, economical way
to clamp material, and is
available on our website.
To Next Page
Loading...