6
Cutting Stakes
WARNING: If the stock comes loose or unclamped while cutting the
stake, DO NOT drop the drill or try to grab the stock! Stop the drill and
remove it from the end of the log. Re-secure the log, and resume
● Obtain the stock you want to point
● Make sure the diameter fits the tool
● Cut it to length and make sure the ends
are flat. If the ends are not even/flat, the
point will be crooked
● If the diameter is larger
than the tool can accept,
taper the end with a
hatchet or draw knife
● Secure the stock in a vise, clamp,
or fixture with a “V” shaped
notch
● The Log Lock (LL1545) is a safe,
easy, economical way to clamp
material, and is available on our
website
Square
Round
Max Capacity
Round 2.00” DIA
Square
To Next Page
Loading...