Lumens VC-B20U - Chapter 6 Descriptions of Major Functions

English -
15
Chapter 6 Descriptions of Major Functions
6.1 I would like to save the current lens position data
1. Press [Preset + ID] on the remote control to save the current position
data.
 ID shall be a digit [0 ~ 9].
 Use VISCA command to store position data to [0 ~ 127]
6.2 I would like to clear the saved position data
1. Press [Reset + ID] on the remote control to clear the given position
data.
 ID shall be a digit [0 ~ 9].
 Use VISCA command to clear position data stored in [0 ~ 127]
6.3 I would like to turn on the back light compensation
function
1. Press [Back Light] on the remote control to turn on or turn off the back
light compensation
6.4 I would like to adjust the shooting angle of the lens
1. Press [Tilt ] or [Tilt ] on the remote control to adjust the angle
upward or downward.
2. Press [Pan ] or [Pan ] on the remote control to adjust the angle to
right or left.
3. Press [Pan - Tilt Reset] on the remote control to reset the angle to the
center point.