3 ASSEMBLY INSTRUCTIONS
HEAD AND FOOT ASSEMBLY
foot
section
head
section
motor cam
hook
rivet
hook
rivet
Assembly, head and foot sections
Note: Grid deck not shown for clarity
1. Place the head and foot sections on their sides at approximately right angles to each other with
motor cams up, as shown above.
2. Slide the head and foot sections together until the foot section’s hook catches the head
section’s rivet on both sides. Ensure both rivets are completely seated before continuing.
Straighten sections
Note: Grid deck not shown for clarity
head wing
straighten
foot
head
linkage plate
3. With the rivets fully seated in the hooks as described in step 2, rotate and straighten the bed as
shown above. Position head wing as shown above.
s
Head
Foot
To Next Page
Loading...