Lumin D2 User Manual

1
Lumïn Bracket manual
Thank you for purchasing the Sbooster-Lumïn bracket to make the Lumïn D2, U1 Mini or T2 suitable for the
Sbooster BOTW P&P ECO 12-13V external power supply. In just 20 minutes of your DIY-time is needed to take
out the stock SMPS of the Lumïn, install the Sbooster bracket and to enjoy more music………
Please note: taking out the SMPS of the Lumïn and installing the Sbooster bracket is at your own risk.
Caution: Watch-out for Electrostatic Discharge (ESD).
Make sure when you are working on the Lumïn that you are fully discharged to prevent damage to the Lumïn.
You can discharge yourself by touching i.e. your grounded device like an Amplifier, Radiator or Fridge, etc.
Needed tools:
- Screw driver
- Torx screw driver (supplied in connection kit)
- Wrench (mini cross wrench supplied in connection kit)
- 2x screws (supplied in connection kit)
- Pliers

Lumin D2 Specifications

General

Brand	Lumin
Model	D2
Category	Racks & Stands
Language	English

Summary

Introduction, Safety, and Tools

Electrostatic Discharge (ESD) Precautions

Warning about electrostatic discharge and how to safely discharge yourself before working on the Lumin device.

Required Tools for Installation

Lists the necessary tools for performing the Sbooster bracket installation on the Lumin device.

Lumïn Bracket Installation Steps

Step 1: Remove Enclosure Screws

Instruction to remove 14 torx screws from the enclosure, internal power supply, and power supply cover.

Step 2: Open Enclosure

Guide on how to open the Lumin device enclosure by sliding the cover towards the back.

Step 3: Remove PSU Connector

Procedure to disconnect the PSU connector from the circuit board, noting the clip mechanism.

Step 4: Remove PSU Cover

Instructions for removing the PSU cover by sliding it forward and then flipping it off the circuit board.

Step 5: Unscrew Wires from Internal PSU

Guidance on unscrewing wires from the internal PSU, specifying not to remove them from the SMPS.

Step 6: Remove IEC Mains Input

Steps to remove the IEC mains input, including removing nuts, torx screws, and cutting a wire.

Step 7: Install Sbooster DC Input Bracket

Instructions for placing and fixing the Sbooster DC input bracket using supplied silver screws.

Step 8: Install Connector to Circuit Board

Procedure for installing the connector onto the Lumin circuit board, checking wire positioning.

Step 9: Install Enclosure Cover

Guidance on re-installing the enclosure cover, with a note on handling the front panel carefully.

Connecting the Sbooster Power Supply

Connecting the BOTW P&P ECO 12-13V MKII

Instructions on connecting the Sbooster BOTW P&P ECO 12-13V MKII to the Lumin bracket and device.

Tight Fit Female DC Connector Handling

Tips for managing a tight fit female DC connector, including using a stock DC plug.