Lumin T2 User Manual

1
Lumïn Bracket manual
Thank you for purchasing the Sbooster-Lumïn bracket to make the Lumïn D2, U1 Mini or T2 suitable for the
Sbooster BOTW P&P ECO 12-13V external power supply. In just 20 minutes of your DIY-time is needed to take
out the stock SMPS of the Lumïn, install the Sbooster bracket and to enjoy more music………
Please note: taking out the SMPS of the Lumïn and installing the Sbooster bracket is at your own risk.
Caution: Watch-out for Electrostatic Discharge (ESD).
Make sure when you are working on the Lumïn that you are fully discharged to prevent damage to the Lumïn.
You can discharge yourself by touching i.e. your grounded device like an Amplifier, Radiator or Fridge, etc.
Needed tools:
- Screw driver
- Torx screw driver (supplied in connection kit)
- Wrench (mini cross wrench supplied in connection kit)
- 2x screws (supplied in connection kit)
- Pliers

Lumin T2 Specifications

General

Brand	Lumin
Model	T2
Category	Racks & Stands
Language	English

Summary

Lumin Bracket Installation Guide

Introduction, Safety, and Tools

Manual overview, ESD precautions, and list of required tools for the installation.

Step 1 & 2: Initial Disassembly

Remove 14 torx screws and slide the enclosure cover to the back.

Step 3 & 4: PSU Component Removal

Disconnect the PSU connector and remove the PSU cover carefully.

Step 5: Disconnect Internal PSU Wires

Unscrew wires from the internal PSU without removing them from the SMPS.

Step 6: Remove IEC Mains Input and Wire

Remove IEC mains input nuts and screws, then cut the red wire.

Step 7: Install Sbooster DC Bracket

Mount the Sbooster DC input bracket onto the unit using silver screws.

Step 8: Connect to Lumin Circuit Board

Connect the newly installed bracket connector to the Lumin circuit board.

Step 9: Reassemble Enclosure Cover

Slide the enclosure cover back and secure the front panel with care.

Step 10: Secure Enclosure

Install the 8 enclosure torx screws to complete the bracket mounting.

Connecting the Sbooster BOTW P&P ECO

Connecting the DC Input

Align the 'S' logos on the bracket and connector for proper insertion.

Tight Fit DC Connector Handling

Tips for inserting a tight female DC connector using a supplied DC plug.

Power On Procedure and Safety

Safe power on sequence, switch usage, and waiting times for the Sbooster.