Lumos Networks DSL Modem - Connecting a Computer

1. Plug one end of the Ethernet cable into your computer’s Ethernet
port and the other end into the DSL Modem’s Ethernet port.
2. The phone cord should already be plugged into the DSL modem
(page 3). If not, plug the phone cord into the DSL Modem and into
your wall jack.
3. The power supply should already be plugged into the DSL
Modem (page 4). If not, plug the power supply into a working
electrical outlet and into your modem. Turn the modem on.
If the DSL light connues to blink, the DSL is not connected, please
recheck the connecon of the DSL lters. Refer to pages 2 - 3:
‘Applying the DSL Filters’ for ‘What devices must be ltered?’
Please avoid passing the DSL Phone cord through a splier or surge
protector.
If the DSL light does not come on check the phone cord connecon
between the DSL modem and wall jack. If the problem sll exists, try
another jack on the same phone line.
Connecng a computer using the Ethernet cable is highly
recommended
Connecng a computer using the ethernet cable.
5
Connecng the DSL Modem
Connecng a computer using the USB cable.
To connect your computer to the DSL modem using a USB cable,
please contact Lumos Networks Customer Technical Support at
1-888-553-6454 for detailed instrucons