INSTALLATION INSTRUCTIONS
ATTACHING THE REMOTE MOUNT TO YOUR HANDLEBARS:
1) Attach the mount to your handlebar using 2 silicone rubber bands. We’ve provid-
ed several bands of various sizes to accommodate dierent handlebar sizes. Ensure
that the mount is securely attached to your handlebar.
2) Place the remote on the mount and twist to lock it in place.
USING THE HELMET
TURNING THE HELMET ON/OFF + SELECTING THE FLASHING MODE
To turn o, press and hold the power button
To change the ashing mode, press the power button for a short press
CHARGING THE HELMET AND REMOTE
Note that when the battery on the helmet is low, the power button will start ashing
red. At this point there is only approximately 30min of charge left in the helmet.
When the battery on the helmet is critically low and is about to shut o, before it
does so the helmet will beep several times to inform you that it is about to shut o.
(in case you are riding with it at the time)
To Next Page
Loading...