What to do if the door pull latch is loose or not working properly on my Lund 1650 EXPLORER?
If the door pull latch on your Lund Boat is loose or not working properly: * Adjust the latch to the proper setting and tighten the set screw on the end of the latch. * Tighten the plastic retaining nut on the underside of the latch to keep the latch from turning.
Why is my Lund 1650 EXPLORER Boat speedometer not working?
There are a couple of reasons why the speedometer on your Lund Boat might not be working: * The pickup at the engine might be plugged. Inspect and unplug it. Alternatively, you can refer to the engine owner's manual or contact a dealer for service. * The hose might be disconnected at the back of the speedometer. Reconnect the speedo hose to the back of the speedometer, using a tie strap to tighten the hose onto the gauge.
What to do if my Lund 1650 EXPLORER is not loading evenly onto the trailer?
If your Lund Boat is not loading evenly onto the trailer, consider these solutions: * Pull the trailer forward. * Back the trailer at an angle that offsets the unlevel ramp. * Straighten the trailer before loading. * Distribute the weight as evenly as possible.
Why is water leaking from underside of console in my Lund 1650 EXPLORER Boat?
The most probable cause is if the speedo hose has become disconnected from the barb on the back of the speedometer. Reconnect the speedo hose to the back of the speedometer using a tie strap to tighten hose onto gauge.
What to do if my Lund 1650 EXPLORER lists while at rest?
If your Lund Boat lists while at rest, it is likely due to improper weight distribution. Distribute the weight evenly throughout the boat cockpit, including the position of passengers and equipment.
What to do if the livewell is not filling in my Lund 1650 EXPLORER Boat?
If the livewell in your Lund Boat is not filling, here are a couple of things to check: * Ensure the spray head is open by turning it counter-clockwise. * Make sure the livewell drain plug or overflow standpipe is installed.
Why LED courtesy flip-lights (Pro V models) will not come on in my Lund 1650 EXPLORER?
If the LED courtesy flip-lights in your Lund Boat (Pro V models) will not come on, ensure the light has been flipped upward or downward to work; the center position is the off position and the light will not come on.
What to do if my Lund Boat air ride pedestal does not travel up or down?
If the air ride pedestal on your Lund Boat does not travel up or down, remove the seat from the pedestal and adjust the screw on top of the post counter-clockwise until movement is achieved or contact dealer for service.
Why does my Lund Boat fuel level varies or is inaccurate?
The fuel level in your Lund Boat may vary or appear inaccurate because the fuel tank geometry contributes to the variation. For the most accurate reading, check the gauge when the boat is level.
Why is my Lund Boat porpoising while underway?
If your Lund Boat is porpoising while underway: * Lower the engine trim angle. * If the engine is equipped with a trim tab, adjust it per the engine owner's manual. * Review the location of passengers and equipment and determine if more weight can be distributed towards the bow of the boat or contact dealer for service.
A checklist for ensuring safe boating practices before trips.
Details required and recommended safety equipment for the boat.
Discusses the dangers of carbon monoxide and prevention methods.
Outlines essential practices for safe operation of the boat.
Explains fundamental principles of seamanship and navigation.
Discusses aids used for safe navigation on the water.
A comprehensive checklist for pre-trip preparation.
Procedures and safety precautions for fueling the boat.
Step-by-step instructions for starting the boat's engine.
Procedures for handling emergencies.
Steps to prepare the boat for winter storage.
Fuel system preparation for storage.
Battery preparation and storage for winter.
Checklist for preparing the boat after storage.
To Next Page
General