After unpacking the hand massager, please check the integrity
of the device and accessorises and look for any damages.
Before first use, charge the massager until the blue level
indicator stops blinking (see below the section how to charge).
Place the device on a flat, level surface.
Insert one hand into the cloth-lined chamber.
Press the Power Button, then the Program Button in order to
start the massage.
NOTE: Please be sure to remove all sharp jewelry.
You should see a blue battery
charge level indicator blinking
while charging. Once the battery
is fully charged, the level
indicator stops blinking. In order
to charge the massager, just
connect the usb cable between
the massager port and any usb
plug (laptop, wall plug, etc.)
IMPORTANT:
Please fully charge the hand massager
before the first use.
Keep in mind that you cannot use the
massager while plugged-in and charging,
due to safety reasons. If the blue light is
not flashing while charging, please report
to the troubleshooting page 19 of this
manual.
Before Using your
Hand Massager
10
FIRST STEP: CHARGING
CHARGING TIME
5V / 1A: Around 7h
5V / 2A: Around 4h
WORKING TIME
Normal Use: Around 3h
With Heat & Vibration: Around 2h
To Next Page
Loading...
Need help?
General
