LUTEC 6211BZ-PIR23A User Manual

Model/ Modelo #6211BZ-PIR23A
WET LOCATION/ UBICACION HÚMEDA
WARNING/ ADVERTENCIA
• Consult a qualified electrician if you are not certain about the installation process.
Always install wiring connections in accordance with local code, ordinances and
the National Electric Code./ Si no está seguro de cómo instalar el producto,
consulte a un electricista calificado. Instale siempre las conexiones del cableado
de conformidad con los códigos y las ordenanzas locales, y el Código Eléctrico
Nacional.
• Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment./ Los cambios o modificaciones a esta unidad no aprobados
expresamente por la parte responsible del cumplimiento podrían anular la
autoridad del usuario para operar el equipo.
• Do not attempt to install this product while it is plugged in./ No intente instalar
cuando está enchufada.
• Do not connect this light fixture to a dimmer switch or timer./No conecte esta
lámpara a un regulador de intensidad o temporizador.
• This light fixture is designed to fit standard junction boxes as defined by the
National Electrical Code./ Esta lámpara está diseñada para adaptarse cajas de
union estándar según lo define el Código Eléctrico Nacional.
• To avoid water damage and the risk of electrical shock, the motion sensor
controls must be facing the ground when installation is complete./ A fin de evitar
los daños producidos por el agua y el riesgo de descarga eléctrica, los controles
del sensor de movimiento deben estar mirando hacia el suelo cuando la
instalación se haya completado.
• Do not install motors, transformers, or fluorescent light fixtures on the same
circuit as the fixture./ No instale motores, transformadores o lámparas de luz
fluorescente en el mismo circuito de la lámpara.
• This fixture is designed for outdoor installation and should be mounted to a
wall or eaves./ Esta lámpara está diseñada para instalación en exteriores y
debe montarse en una pared o un alero.
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
Lea y comprenda completamente este manual antes de intentar ensamblar, usar
o instalar el producto.

LUTEC 6211BZ-PIR23A Specifications

General

Model	6211BZ-PIR23A
Category	Flood Light
Power	20W
Material	Aluminum
Sensor Type	PIR
IP Rating	IP65
Voltage	220-240V
Frequency	50/60Hz
Beam Angle	120°
Motion Sensor	Yes
Detection Range	12m
Detection Angle	120°
Lifespan	25000 hours

Summary

Installation Warnings

Consult Qualified Electrician

Consult a qualified electrician for installation. Ensure wiring connections comply with local and National Electric Codes.

Modification Restrictions

Unauthorized modifications void user authority. Changes not expressly approved by the responsible party may void compliance.

Installation Safety Precautions

Do not install while plugged in. Avoid connecting to dimmer switches or timers. Ensure motion sensor faces ground.

Circuit Compatibility

Do not install motors, transformers, or fluorescent fixtures on the same circuit as this fixture.

Outdoor Installation Design

Fixture designed for outdoor installation. Mount to a wall or eaves for exterior use.

Operation Modes and Settings

TEST Mode Operation

Sensor detects movement and activates light regardless of time. Light remains on briefly after movement stops.

SECURITY Mode Operation

Motion sensor active at dusk. Light activates with movement, stays on for set time, then turns off. Deactivates at dawn.

Time and Distance Settings

Adjust detection time (1, 3, 10 min) and distance (L, M, H) for security mode.

Manual Override Function

Force fixture to override TEST/SECURITY modes, keeping light on manually via wall switch.