98
by Lutron
Multi-Location Installation - Caséta Diva Smart Dimmer with Claro Smart Accessory Switch (DVRF-6L / DVRF-AS)
1
Identify existing wiring
2
What you need for a multi-location installation
WARNING! Shock Hazard. May result in Serious
Injury or Death. Turn off power at circuit breaker
before installing the unit.
4
Turn power off at circuit breaker
5
Remove existing switch from wall at Location 1
- If one switch controls the lights (single-pole installation)
See quick-start guide that came with your dimmer
- If two switches control the lights (3-way installation)
See page 27, page 44, or page 50 for details
Important note:
Two Claro Smart accessory switches
DVRF-AS
3
Choose a location for your Caséta Diva Smart dimmer
NOTE: There will be two different types of existing switches in this
application. Locations 1 and 3 will use 3-way switches (three screws
which control the lights, plus one ground screw) and Location 2 will use
a 4-way switch (four screws which control the lights, plus one ground
screw). For easiest installation, we recommend replacing one of the 3-way
switches with your dimmer (Locations 1 or 3). In this example, we will use
Location 1.
Location 1
3-Way Switch
(Locations 1 and 3)
4-Way Switch
(Location 2)
+
Three or more switches control the lights
(multi-location installation)
Location 1 Location 2 Location 3
Diva Smart dimmer
DVRF-6L
+
Three Claro wallplates
CW-1
To Next Page
Loading...