Lutron Electronics Maestro MS-OPS2H C Series - 3-Way Installation (120 V) with Standard Switch

Maestro Sensor
369666f 10 09.05.19
®
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Switch with Occupancy / Vacancy Sensor
1
When using controls in single location installations, tighten the blue terminal or cap blue wire. Do not connect the blue terminal / wire to any other
wire or to ground.
2
Only one occupancy sensor switch can be used per multi-location circuit.
3
A single standard mechanical 3-way switch or up to 9 companion switches may be connected to most occupancy sensor switches.
Standard mechanical 3-way switch cannot be combined with companion switch. Total blue terminal wire length may be up to 150ft (46m).
Wiring Diagrams (continued)
Note: When a neutral connection is available, remove the green sleeve and connect the white wire to neutral.
Continued on next page...
Black
Blue
White
Ground
Green
screw
Ground
120 V~
50 / 60 Hz
Hot / Live
Neutral
Load
Standard
mechanical switch
Black
Jumper wire
Bare
Different color
screw (Common)
OR
Black
Blue
Ground
White
Ground
120 V~
50 / 60 Hz
Hot / Live
Neutral
Load
Standard
mechanical switch
Black
Jumper wire
Bare
Different color
screw (Common)
Green
screw
3-way Installation with Standard Mechanical Switch (120 V~)
2, 3
-OPS5M, -OPS6M2-DV, -VPS5M, -VPS6M2-DV
Wiring Diagram 3 - with Neutral
Occupancy
sensor switch
Occupancy
sensor switch
10