Lutron Electronics SeeTouch QS Series - Installation

Occupant Copy Installation Instructions3
Installation
Warning! Shock hazard. May result in
serious injury or death. Always turn OFF the
circuit breaker/MCB or remove the main fuse
from the power line before doing any work.
1. Turn Power OFF. Turn power OFF as
circuitbreaker/MCB (or remove fuse).
2. Mount Wallbox. Wallstations mount in a Lutron
wallbox (P/N 241-683) or in German and UK
backboxes (60.30 mm measured center to center of
mounting holes).
3. Prepare Wallstations. Remove the faceplate and
set aside.
ON
OFF
ON
OFF
ON
OFF
4. Prepare wires. Strip insulation from wires so that
9.5 mm (3/8 in.) of bare wire is exposed.
Each wallstation terminal accepts up to two
1.0 mm
2
(#18 AWG) wires.
Note: Wiring may be done in a Daisy-Chain or
T-Tap configuration, as shown below.
9.5 mm (3/8 in.)
LUTRON
LUTRON
LUTRON
LUTRONLUTRON
LUTRON
LUTRON
LUTRON
LUTRON
LUTRON
LUTRON LUTRON LUTRON
LUTRON
LUTRON
LUTRON
LUTRON
LUTRONLUTRON
LUTRON
LUTRON
LUTRON
LUTRON
LUTRON
LUTRON LUTRON LUTRON
LUTRON
Daisy-Chain
T-Tap