Application Note #734
10 www.lutron.com/support
Light Bar Brightness Mode
Adjust the brightness of the LEDs on the light bar in the Active, Light Level Indicator, and Locator Light states.
Select between high-, medium-, and low-brightness of the control’s light bar.
Default Setting: Medium brightness
1. Pull the Front Accessible Service Switch (FASS) out to the
open position.
2. Press and hold the
Off
button. (Press the left side of the button to
not mistakenly affect the light bar.)
3. While continuing to hold the
Off
button, push the Front Accessible
Service Switch (FASS) in to the closed position. Continue to hold the
Off
button for approximately 6 seconds. The light bar will begin to
flash slowly (~4 times/second).
4. Release the
Off
button and LED 1 will continue to flash slowly
(~4 times/second).
Note: The control will automatically exit this menu after 1 minute
of inactivity.
PULL
PRESS AND HOLD
MIN
SEC
PUSH
HOLD
RELEASE
(continued on next page . . .)
To Next Page
Loading...
