Application Note #734
3 Customer Assistance — 1.844.LUTRON1
3
High-End Trim Shortcut
Default Setting: Highest level of trim range.
1. To enter High-end Trim, touch the top of the light bar continually
for about 6 seconds. (DO NOT depress the
On
button.) The device
will go to high-end and the light bar will begin flashing slowly
(~4 times/second).
2. Remove your finger and the light bar will begin to flash quickly
(~8 times/second) indicating the current high-end trim level.
Note: The control will automatically exit high-end trim mode
after 1 minute of inactivity.
3. Slide your finger up or down the light bar to set the maximum light
level (high-end). The trim setting follows your finger as it is adjusted.
4. Once the maximum light level is acceptable, Tap the
Off
button to
confirm your setting and exit into Normal Operation.
Note: If at any time you are not happy with the settings you have
achieved, you may Restore Factory Default Settings. See page 14
for details.
MIN
SEC
This feature allows the user to determine the maximum light level and adjust the settings accordingly.
It is typically used to avoid undesirable lamp behavior near high-end or to reduce power consumption.
TOUCH
RELEASE
SLIDE
TAP
To Next Page
Loading...
