Application Note #734
4 www.lutron.com/support
Low-End Trim Shortcut
Default Setting: Middle level of trim range.
1. To enter Low-end Trim, touch the middle of the light bar continually
for about 6 seconds. (DO NOT depress the
On
or
Off
button.)
The device will go to low-end and the light bar will begin flashing
slowly (~4 times/second).
2. Remove your finger and the light bar will begin to flash quickly
(~8 times/second) indicating the current low-end trim level.
Note: The control will automatically exit low-end trim mode
after 1 minute of inactivity.
3. Slide your finger up or down the light bar to set the minimum light
level (low-end). The trim setting follows your finger as it is adjusted.
4. Once the minimum light level is acceptable, Tap the
Off
button to
confirm your setting and exit into Normal Operation.
Note: If at any time you are not happy with the settings you have
achieved, you may Restore Factory Default Settings.
See page 14 for details.
MIN
SEC
1
Occurs when low-end trim is set too low for a given bulb’s design capabilities, which can
shorten lamp life.
This feature minimizes LED bulb flickering and strobing
1
when the dimmer is at the minimum light level. This feature can
also be used to set a personal preference.
TOUCH
RELEASE
SLIDE
TAP
To Next Page
Loading...
