Lutron Electronics Sunnata ST-PRO-N - Page 5

Application Note #734
5 Customer Assistance — 1.844.LUTRON1
®
Phase-Select Mode (PRO-N only)
1. Pull the Front Accessible Service Switch (FASS) out to the
open position.
2. Press and hold the
On
button. (Press the left side of the button to
not mistakenly affect the light bar.)
3. While continuing to hold the
On
button, push the Front Accessible
Service Switch (FASS) in to the closed position. Continue to hold the
On
button for approximately 6 seconds until LED 1 and LED 9
start flashing.
PRESS AND HOLD
PULL
MIN
SEC
(continued on next page . . .)
PUSH