Lutron Electronics Sunnata ST-PRO-N - Page 6

Application Note #734
6 www.lutron.com/support
®
Phase-Select Mode (PRO-N only) (continued)
4. Release the
On
button and LED 1 or LED 9 will continue to flash
slowly (~4 times/second) to indicate current phase mode.
- LED 9 - Forward-phase
- LED 1 - Reverse-phase (default)
Touch the light bar to select the desired phase.
Note: The control will automatically exit low-end trim mode after
1 minute of inactivity.
Exit Phase-Select Mode
5. Press and hold the
On
button for approximately 6 seconds to
save and exit.
RELEASE
LED 9: Forward-phase
LED 1: Reverse-phase
(default)
On
Off
MIN
SEC