Luxman D-07X User Manual

20
SUPER AUDIO CD PLAYER D-07X
Before connecting
Before connecting other devices, connect the jack side of the
accessory power cable to the AC inlet of this unit.
When connecting, turn off the power supply for this unit and
the power supplies of all auxiliary devices to prevent unex-
pected accidents that may be caused by noise.
Connecting to the power supply
Connect the supplied accessory power cable here to power
the unit from an AC wall outlet.
How to connect input devices
1. Digital connection from a PC/Mac (Refer to
the connection diagram (A).)
Connect between the USB (A-type) terminal of the PC or
Mac and the USB (B-type) terminal of this unit with a USB
cable.
Before connecting this unit to a PC or Mac the dedicated
driver software needs to be downloaded from LUXMAN
website and installed.
Refer to “Driver Installation Manual” on the LUXMAN website
for detailed information.
Caution:
Connection between a PC
or Mac and this unit using a USB
cable should not be performed before the installation of the
dedicated driver software is completed. Failure to observe this
may cause a malfunction.
2. Digital connection from a device such as a
CD player (Refer to the connection diagrams
(B) and (C).)
Connect between the (coaxial or optical) digital output ter-
minal of a CD player, an SACD player, a DVD player or other
such devices and the digital input terminal (COAX/OPT) of
this unit with a coaxial digital cable and an optical digital
cable.
This terminal is a shutter-type optical terminal. Direct the
cable connector correctly when inserting the cable into the
terminal. If the cable connector is inserted forcibly in the
wrong direction, the terminal may be deformed and the
shutter may not be able to close even after disconnecting
the cable.
The optical terminal is mounted as illustrated.
Lower side
Upper side

Luxman D-07X Specifications

General

Brand	Luxman
Model	D-07X
Category	CD Player
Language	English