2
SUPER AUDIO CD PLAYER D-07X
How to handle discs
• Do not use any deficient disc (cracked, warped, etc.).
• Do not damage the signal surface of the disc or make it
dirty.
• Do not place paper or a stickers on the disc. Such awk-
ward handling can warp the disc and playback may be-
come impossible. In many cases, rental discs carry labels
and glue may leak from under the label. Before use, check
that the disc is free from leaking glue or the like.
• Do not play two discs in a stack.
• Some discs with a printable surface, so-called “printable
CD-Rs”, easily stick to the mechanism which holds the CD
during playback. Please do not use such discs as it may
become impossible to eject the disc or cause a failure of
the unit.
How to store discs
• Always put your discs in a case. Store them vertically
where high temperature, high humidity, and direct expo-
sure to sunlight are not prevalent. Places with extremely
low temperature should also be avoided.
• Read the caution notes carefully that are attached to discs.
Disc cleaning
• If a disc is dirty from fingerprints or dust, this may affect
sound quality. Lightly wipe the disc with soft cloth, from the
inside to outer edge. (Don’t wipe it with a circular motion.)
• Do not use a volatile chemicals such as benzine or thinners.
Record spray, anti-static agents, and other such cleaners
must not be used either.
• If a disc seems to be very dirty, dip soft cloth in water, wring
it well, wipe away the dirt and finally remove the moisture
with dry cloth.
Specifically designed discs
This unit cannot play discs with specifically designed shapes
such as heart-shaped or hexagonal discs. Never use such
discs as they can cause malfunctions.
Lens cleaning
If the lens gets dusty, discs may skip during playback. Please
read “After-sales Services and Quality Assurance” and ask
us for cleaning. Do not use any commercial cleaning discs
available because they may damage the lens.
Notice on handling optical digital cables
• Do not fold the cables. For storage, wind each cable into a
coil about 15 cm in diameter or larger.
• For connection, insert the cable connectors firmly into the
terminals of this unit and the other device.
• Only use 3 meter long cables or shorter.
• When the cable connectors get dusty, wipe the dust away
with a dry soft cloth before inserting into the terminals.
Cleaning
• Usually, wipe the unit with a dry soft cloth. When the dirt is
hard to remove, dip a soft cloth in detergent diluted 5 or 6
times with water, wring it well, and remove contaminants.
Then, remove the moisture with dry cloth.
• Do not use a solvent like alcohol, benzine, thinner, or pes-
ticide because such a substance can damage the exterior.
In addition, do not let this unit contact rubber or plastic
foam for a long time. That may damage the cabinet surface
of the unit.
• Before cleaning, unplug the power cable from the AC outlet.
Safety caution
Caution
This unit is heavy. Be careful when unpacking, carrying, and
installation.
To Next Page
Loading...
Need help?
General
