Why does my Lydsto R3 Vacuum Cleaner fail to boot?
If your Lydsto Vacuum Cleaner fails to boot, it could be due to several reasons: a low battery - place the robot on the charging base, align it with the point, it will start automatically; the robot is being used outside of its optimal environment of 0 to 40 ° C; or the plug of the power adapter is not properly connected. Please check these possible causes.
What to do if my Lydsto R3 Vacuum Cleaner has reduced cleaning ability or dust?
If your Lydsto Vacuum Cleaner's cleaning ability is reduced or you notice more dust, the HEPA filter may be blocked and needs replacement or the roll brush may be wrapped and needs cleaning.
What to do if Lydsto R3 Vacuum Cleaner won't charge?
If your Lydsto Vacuum Cleaner is not charging, the contact may not be good. Please clean the dirt on the charging point or remove the side brush. Also, the robot may be too far away from the dust collector, place it near the dust collector.
Why is my Lydsto Vacuum Cleaner making a strange noise?
If your Lydsto Vacuum Cleaner is making a strange noise, the dust box might be full. Please clean it.
What to do if Lydsto R3 displays 'Please check the roll brush'?
If your Lydsto Vacuum Cleaner displays 'Please check the roll brush', the roll brush might be stuck or wound. Check and remove any foreign matter.
What to do if Lydsto R3 Vacuum Cleaner displays 'Please check the side brush'?
If your Lydsto Vacuum Cleaner displays 'Please check the side brush', the side brush might be stuck or wound. Check and remove any foreign matter.
What to do if Lydsto R3 displays 'Off the ground, please return to the ground to start'?
If your Lydsto Vacuum Cleaner displays 'Off the ground, please return to the ground to start', pick up or suspend the robot, move it to the flat ground before starting.
Why Lydsto R3 Vacuum Cleaner schedule-clean failure?
Schedule-clean for the Lydsto Vacuum Cleaner will only start when the power is ?15%.
What to do if Lydsto R3 Vacuum Cleaner displays 'Please wipe wall-sensor'?
If your Lydsto Vacuum Cleaner displays 'Please wipe wall-sensor', it means the wall-sensor is abnormal. Clean and wipe it.
What to do if Lydsto R3 displays 'Dust bag is not installed properly'?
If your Lydsto Vacuum Cleaner displays 'Dust bag is not installed properly', check that dust bags are properly installed.
General| Battery Capacity | 5200 mAh |
|---|---|
| Dustbin Capacity | 600 ml |
| Water Tank Capacity | 300 ml |
| Navigation Type | Laser Navigation |
| Control Method | App, Voice Control |
| Noise Level | 65 dB |
| Automatic Dirt Disposal | Yes |
| Filter Type | HEPA Filter |
| Charging Time | Approximately 5 hours |
To Next Page
