CARE & USE/INSTALLATION
|
13
Use only the mounting brackets provided with this
heater. Heater must be installed in a horizontal
manner parallel with the ground. The heater can,
however, be tilted upward to a maximum of 30
degrees. NEVER mount the heater on a vertical
axis. Such an installation is considered unsafe and
will void all warranties.
Important Note!
EAVE FASCIA MOUNTING
If the heater will be mounted on the fascia of an eave,
then the heater shall be mounted with the brackets in the
EXTENDED position only. The heater shall be mounted
in either the straight down position, or angled upward
to a maximum of 30 degrees AWAY from the house.
CAUTION: DO NOT MOUNT HEATER FACING TOWARD
the house. This position would allow exhaust heat to be
directed toward the combustible surfaces. It is important
to note that when mounting on a fascia the lower pivot
mounting screw (normally located within the curved slot)
will NOT be used.
In all mounting configurations, it is critical to NOT exceed a MAXIMUM pivot angle of 30 degrees. When using this
mounting configuration, since the lower pivot bolt will not be used, the maximum angle control slot will also not be
used.
The maximum 30 degree pivot angle can be determined by sighting the angled surface near the top of the heater.
When this surface is parallel with the ground, the heater is at 30 degrees ( See illustration on page 9). When mounting
on a fascia, NO PORTION OF THE HEATER SHALL BE CLOSER THAN 12 INCHES FROM THE FASCIA SURFACE.
To Next Page
Loading...
Need help?
General