Languages served
6. Storing the honey extractors
Once the honey harvesting has terminated the device
is to be washed thoroughly.
Prior to the honey extractor start-up, in case when it
has been transferred from a room with a lower ambient
temperature to a room with a higher one , one must
wait until the device has reached the ambient
temperature.The device is to be stored in dry rooms
with the temperature above 0º C.
Before every season, an additional technical inspection
must be performed and n case when any defects have
been detected , a service centre must be contacted
.
7. Maintenance and cleaning the honey
extractors
IMPORTANT!
Prior to starting the maintenance, the plug must be
taken out!
After honey harvesting time honey extractor shall be
washed thoroughly with hot water containing slight
quantities of agents accepted to be used in devices
intended to come into contact with food or by means of
a pressure washer. Be careful during the washing and
prevent dumping the honey extractor engine or
controller ( they may be covered with water-resistant
materials)
While washing, the bearings placed under the drum
cannot be flooded. Therefore, the orifice through which
the basket axis goes must be covered inside the drum.
After washing, the honey extractor must be rinsed with
pure water and dried.
7.1. Dismantling the basket in honey extractor
with bottom drives
• Unscrew the engine and the transmission
• Remove and pull out the wedge from the basket
axis
• Unscrew the bolts fixing the beam with the
plexiglass and remove it
• Remove the basket
7.2. Dismantling the basket in honey extractors
with upper drives
• Unscrew the bolts fixing the beam
• Unscrew the bolt fixing the plexiglass
• Remove the upper beam with the plaxiglass
• Remove the basket
8. Recycling
Worn-out product must be removed as waste only within
selective waste collection organised by the Network of
Communal Electric and Electronic Waste Collecting
Points. A customer is entitled to return the used
equipment to the electrical equipment distributor network,
at least free of charge and directly, if the device to be
returned is of proper type and serves the same purpose
as the newly purchased device
9.Guarantee
Product purchased from “Łysoń’ company are
encompassed by the manufacturer’s guarantee.
The guarantee period does not include the controlling
elements and electric drive and fittings. Such ones are
encompassed by a two-year guarantee.A receipt or a
VAT invoice is issued for each product purchased.
ATTENTION!!!
Device cover to be washed with soapy water
at room temperature 25
IMPORTANT!!!
Do not use any detergents with alcohol
(causes cracking in plexi glass)
To Previous Page
Loading...