Lytx SF Series User Manual

Page 1 of 51
(North America Edition)
©2019 Lytx, Inc. - Confidential & Proprietary.
Lytx
®
SF-Series Event Recorder
Installation Instructions
(North America Edition)
Last updated: 4/1/2019
THE DEVICE SHOULD BE INSTALLED AND MAINTAINED BY QUALIFIED TECHNICIANS. Only a properly qualified technician
should install and maintain the SF-Series device. Any electrical work should be performed only by an ASE (minimum T6
& L2), MECP or equivalent certified technician with an expertise in installing and troubleshooting advanced vehicle
onboard components including multiplexed circuits. Lytx, Inc. disclaims all responsibility for any damages arising from
improper installation and maintenance of the SF-Series device.
This guide is protected as confidential and proprietary information of Lytx, Inc. Copying and use of this guide for any
purpose other than installing SF-Series in vehicles of Lytx, Inc.’s customers is expressly prohibited. Information
contained in this guide was in effect as of the date set forth above and is subject to change without notice or liability.
Lytx, Inc. reserves the right to revise the information presented or to discontinue the production of parts described at any
time.

Lytx SF Series Specifications

General

Category	Voice Recorder
Manufacturer	Lytx
Series	SF Series
Recording Time	Varies depending on usage and settings; not specified in available documentation
Battery Life	Varies depending on usage and settings; not specified in available documentation

Summary

Safety Instructions

Installation Safety Warnings

Essential precautions for installing the SF-Series device to prevent injury or damage.

Driver Safety Warnings

Guidelines for driver responsibilities and the role of the event recorder in vehicle safety.

Device Installation Overview

Installation Warnings

Critical warnings for qualified technicians regarding device installation and maintenance.

SF-Series Installation Procedures

Mount the Bracket and Event Recorder

Instructions for physically attaching the mounting bracket and event recorder.

Mounting Location Recommendations and Restrictions

Prepare the Mounting Location

Steps for cleaning and preparing the vehicle windshield for bracket adhesion.

Attach the Bracket and Event Recorder

Detailed instructions for securing the bracket and mounting the device.

Connect Electrical Wiring

Guidance on connecting the device's power and data cables to the vehicle.

Wiring Safety Warnings

Crucial safety warnings related to vehicle wiring and connections.

Wiring and Wire Termination Suggestions

Basic Event Recorder Electrical Connections

Details on the essential power, ignition, and ground wire connections.

Route the Device Power Cable

Run Testing and Complete Installation

Test Event Creation and Upload

Steps to create a test event and verify successful upload to Lytx.

Test Wire Connections and Settings in the Lytx Installation Tool

Procedure to verify wiring and device settings using the Lytx Installation Tool.

Conduct Final Checks

Maintenance & Troubleshooting

Troubleshooting Installation Issues

Guidance for resolving common problems encountered during installation.

Troubleshooting Issues After Installation

Initiate Diagnostic Mode

Troubleshooting in Diagnostic Mode

Uninstalling the Device