8. The installation program will inform you of a successful hardware
installation. Click “Next.
9. This next screen explains that your computer now needs to be
restarted. Make sure that the box labeled,“Yes…” is checked, then click
“Finish” to continue restarting.
NOTE: If you un-check the box labeled,“Yes…” you will again, with a
new screen, be prompted to restart. This is because DMA Mode has
been enabled.
10. You may now connect the MobilePre USB to your computer (refer to
the Hardware Installation section of this manual for instructions).
11. After your MobilePre USB has been connected and your computer has
finished restarting, installation will have been completed.
11
To Next Page
Loading...
