!
Caution!
• The lock has been designed for use in a temperature range from +10˚C to +50˚C and a non-
condensing humidity range from 30% to 80%.
• It may only be cleaned with a moist cloth (do not use aggressive cleaning agents).
• The lock may only be installed by qualified fitters.
• The lock may not be lubricated.
• Never open the lock housing. If it is necessary to disassemble the hardware, only do so in accord-
ance with the technical instructions. If you fail to do so, the lock may no longer function properly
and you will forfeit your right to warranty.
2 SYMBOLS AND SIGNALS
double audible tone, correct
entry
LED flashes
1
2
...
digit on keypad
long audible tone, incorrect
entry
LED illuminated
press and hold
3 OPENING THE LOCK
1
2
3
4
5
6
Enter the code (Manager Code set at the factory = 1-2-3-4-5-6), if the code is correct, a double signal
sounds, you can now unlatch the door and open it. If the door is not opened within 3 seconds, the lock
will automatically engage again. EM3020: to close the lock, press any key.
4 OPEN WITH TIME DELAY
For example!
1
1
1
1
1
1
Enter the code (i.e. 1-1-1-1-1-1), after entering a right code, a double signal sounds
and time delay starts. During time delay expires, the light flashes every 10 seconds. After time delay
has elapsed, a double signal sounds and the open window starts.
To Next Page
Loading...
