● Time, adjust the feedback speed of echo repeats, 600-60bpm.
● Feedback, the feedback times of echo repeats.
● Mix, Adjust the d and wet ratio.
● Grit, the GRIT takes on the function of TAPE BIAS. This parameter
adjusts tape machine bias, from under biased to over-biased, it
sounds like an overdrive of wet sounds. Bias sets the dynamic range
and headroom of the wet signal.
● Speed, the SPEED takes on the function of TAPE CRINKLE. This
parameter adjusts the amount and severity of tape irregularities,
including friction,creases,splices and contaminants. Tape Crinkle
characteristics track accordingly to tape speed. Set to minimum for a
fresh,clean tape. Set to maximum for a tape that has been mangled
and chewed for years.
● Depth, This parameter control varies the amount of mechanically
related tape speed uctuations. This also results in natural tape
machine style modulation, it's like a chorus. Parameter minimum for a
more tuned,cleaned and seiced tape machine. Parameter maximum
to hear the sound of a tape machine in need of seice. In between
the extreme settings, a natural tape modulation is achieved.
4. Dual Delay, two independent delay echoes, the time-lag of the
rst echo and the second echo achieves a ve interesting delay
rhythm eect.
● Time, adjust the feedback speed of echo repeats, 1200-120bpm.
● Feedback, the feedback times of echo repeats.
● Mix, Adjust the d and wet ratio.
● Time-Mode, Adjust the time-lag between the two echoes, the
minimum is the equivalent of no time-lag, and the greater the
number, the greater the time-lag.
● Speed, the Chorus eect is increased in the Delay wet sound. This
parameter can adjust the speed of Chorus used.
● Depth, this parameter adjusts the depth of the Chorus.
10
To Next Page
Loading...