Display
The MA 2Port and 4Port Node WM display will only show the most important settings. For configuring a node, you
have to use a grandMA console.
After switching the device on, the display will show this menu (image shows 2 Port version):
Name of MA 2/4Port Node e.g. 2Port
DMX Output e.g. 30 = frequency of DMX-output in Hz; max. 30Hz possible
IP – Address e.g..192.168.0.244
Mode MANET2 or ARTNET
Number of Session e.g. Session 1 - MA 2Port Node is part of session 1
e.g. Session 0 = no session
e.g. Session 3 + areas OUT grey highlighted = no active session
Configuration of DMX-Ports In – this port receives DMX
OUT – this port sends DMX
Flashing frequency of the green area corresponds to the
refresh quote between MA Node and console
OFF – this port is off
Univers Univers number of respective ports 1 - 256
To Next Page
Loading...
