mabe aqua saver - Troubleshooting Cycle Completion and Water Usage; Incomplete Wash Cycles; Low Water Level Perception

71
Softener is not
released.
Washing
machine does
not complete
the cycle.
•
•
•
•
Operating
problem
Possible cause What to do
Very little
water is seen.
•
•
•
•
•
•
The Soak cycle was
selected.
It is normal if you selected
the Soak cycle, as it only
performs a gentle
agitation.
The low level of water
causes mistrust as to
proper washing or
treatment of clothes.
The washing machine
uses very little water for
the rinse cycle.
This is normal, the soak cycle does not rinse,
therefore the softener will not be released.
If you want it to perform a complete cycle, select
proper program according to the type of clothes.
The AquaSaver system adjusts the necessary
water level according to the amount and type of
clothes to wash.
It is normal to sometimes see clothes above the
water level as it is running. In the case of needing
more water, it will automatically adjust during
the agitation phase.
If this causes mistrust, use the water level knob
and set to a higher level. Either way this washing
machine uses much less water than a traditional
one.
The AquaSaver system uses a new rinsing
method with low water levels and you can trust
that the clothes will be rinsed equally or better
than your prior washing machine.