72
Operating
problems
Possible cause What to do
Entry hose
has water
leak.
•
Clothes have
foam.
•
•
•
Use loam foam detergent. •
•
•
Use the detergent dispenser. •
•
•
Washing
machine does
not wash.
Clothes with very tough•
stains.
•
•
•
•
•
•
•
Close the tap, disconnnect the hoses, ensure
that the hoses have the gaskets and reconnect,
making sure it is tightened properly at the tap as
well as at the washing machine inlet.
Use the amount of detergent recommended by
the manufacturer.
When washing clothes that have a low level of
dirtiness, use less detergent to prevent
generating an excessive amount of foam.
The hoses are not
properly connected.
•
You used high foam
detergent.
The clothes were not
too dirty and you used
too much detergent.
The clothes were not
properly arranged.
Arrange the clothes in the washing machine
according to the instuctions in this manual.
If at the end of the cycle you think that the
clothes still have too much soap, in personal
touch select the “rinse and spin” option.
Soak the garments with tough stains with
detergent or pre-treat the stains with a
commercial stain remover.
Note: For further information on treatment or removal of
tough stains go to the “advice” section in the user
manual.
Pre-treat the garments with a commercial
orhome stain remover.
Use the heavy duty cycle. This cycle is more
intense and if you prefer select the soak option
with the personal touch button.
If they are garments that do not fade, or that are
white, use hot water with the temperature knob.
Use the proper cycles according to the type of
clothes.
When you wash very dirty clothes, do not place
large laundry loads, this will help you to increase
washing performance.
You overloaded the
washing machine with
very dirty clothes.
To Next Page
Loading...
