mabe EML27WWF0 - Clean Cycle and Error Code Troubleshooting; Clean Cycle Problems and Solutions; Error Codes and Locked Display

Ingeniería de Servicio
70
“Crackling” or “popping”
sound
This is the sound of the
metal heating and cooling
during both the cooking
and cleaning functions.
This is normal.
Excessive smoking
during a clean cycle
Excessive soil.
Touch the CLEAR/OFF pad. Open the
windows to rid the room of smoke. Wait
until LOCKED/DOOR goes off. After the
oven cools, wipe up the excess soil and
reset the clean cycle.
Oven door will not open
after a clean cycle
Oven too hot.
Allow the oven to cool below locking
temperature.
Oven not clean after a
clean cycle
Oven controls not properly
set.
See the Using the self-cleaning upper
and lower ovens section.
Oven was heavily soiled.
Clean up heavy spillovers before
starting the clean cycle. Heavily soiled
ovens may need to self-clean again or
for a longer period of time.
“LOCKED” flashes in the
display
The self-clean cycle has
been selected but the door
is not closed.
Close the oven door.
“LOCKED” is on when
you want to cook
The oven door is locked
because the temperature
inside the oven has not
dropped below the locking
temperature.
Touch the CLEAR/OFF pad. Allow the
oven to cool.
“F” and a number or letter
flash in the display
You have a function error
code.
Disconnect all power to the range for at
least 30 seconds and then reconnect
power. If the function error code
repeats, call for service.