mabe EML27WWF0 - Display and Operational Faults; Locked Display and Control Signals

Ingeniería de Servicio
71
Range Locked or LOC
On appears in the oven
display or LC appears in
the surface display
The controls have been
locked.
See the Control Lockout section to
unlock.
Control signals after
entering cooking time or
start time
You forgot to enter a bake
temperature or cleaning
time.
Touch the BAKE pad and desired
temperature or the SELF CLEAN pad
and desired clean time.
Display goes blank
A fuse in your home may
be blown or the circuit
breaker tripped.
Replace the fuse or reset the circuit
breaker.
The clock is in the black-
out mode.
See the Special features of your oven
control section.
Display flashes
Power failure.
Reset the clock.
Unable to get the display
to show “SF”
Oven control pads were
not touched properly.
The BROIL HI/LO and BAKE pads must
be touched at the same time and held
for 3 seconds.
Power outage, clock
flashes
Power outage or surge.
Reset the clock. If the oven was in use,
you must reset it by touching the
CLEAR/OFF pad, setting the clock and
resetting any cooking function.
Steam from the vent
When using the ovens, it
is normal to see steam
coming out of the oven
vents. As the number of
racks or amount of food
being cooked increases,
the amount of visible
steam will increase.
This is normal.
“Burning” or “oily” odor
emitting from the vent
This is normal in a new
oven and will disappear in
time.
To speed the process, set a self-clean
cycle for a minimum of 3 hours. See the
Using the self-cleaning upper and lower
ovens section.