75
In case of a spillage, you can take the following steps to
easily clean the exterior door:
To remove and replace the exterior door of your Smart
Station you will need a small screwdriver:
Open the exterior access door1.
Use the at part of the screwdriver to remove the 2.
door from the base on the left hand side.
Find the hinge and screw the screwdriver into it.3.
Once you have unscrewed the hinge, pull the 4.
door to the right until it comes away.
To replace the door, rst attach it to the bolt on 5.
the right-hand side.
Slide the edge to the right using the screwdriver, 6.
and align it with the marked groove.
Use light movements until you hear a click 7.
indicating that the door is properly positioned.
smart fill ice factory
(only available with certain models)
This no-spill ice-maker with removable cylinder feeds directly into the ice-tray.
It comes with a storage box that can hold up to 900g of ice.
starting up:
Remove the water cylinder found at the top of
the Smart Fill Ice Factory (SFIF) by pulling the
top middle part towards you.
Once removed, place the water cylinder on a
at surface. Open the top, which you’ll nd in
the middle centre. To avoid spillages, make sure
that there’s no residual ice obstructing the valve
of the cylinder before you ll it with water. Pour
180 ml of puried water into the cylinder or ll
it to the maximum level.
Replace the top, placing pressure on the
middle. It’s essential that it’s secure in the centre
in order to avoid water leaking out.
Put the cylinder back in its original position
making sure it’s securely connected. You should
be able to see and hear the water lling the
ice-tray which indicates that the cylinder is
correctly installed.
To Next Page
Loading...
