Mac allister MBC3630 - Product Functions and Harness Usage

EN
30
In
more
detail...
MBC3630
by MacAllister
Intended use
Harness
This cordless 2-in-1 brush cutter MBC3630 is designated with rated voltage of
36 V . It is designed only to be used with the battery pack MDVB36-4 and
the charger MFC36.
With the trimmer head attached the product is intended to cut smaller types of
weed, lawn grass or similar soft vegetation.
With the cutter blade attached, the product is intended to cut heavier weeds,
brush and similar vegetation with a thickness of up to 10 mm.
The product should not be used to cut unusually thick grass or vegetation, wet
grass or to shred leaves etc.
For safety reasons it is essential to read the entire instruction manual before
rstoperationandtoobservealltheinstructionstherein.
This product is intended for private domestic use only, not for any commercial
trade use. It must not be used for any purposes other than those described.
The harness (22) helps the operator to carry the product.
1. Adjust the position of the suspension sleeve (12) if necessary. Make sure it is
wellxedontheupperpole(9)beforeoperation.
2. Place the harness (22) so that
• the securing clip (22a) and hip protection pad (22b) are on the right side,
• the quick release lever (22c) is in front;
• all strap closures are securely fastened,
• the belts must be tensioned in a way that the load is distributed evenly on
the shoulders (Figs. 13, 14).
Product functions
22b
22a
22c
22
Fig. 13
22
Fig. 14