MIS2400 by MacAllister
Getting started...
EN
17
Before you start
WARNING! Always operate the product with its collection bag (5)
attached to protect yourself against ying debris and to avoid injuries!
Do not use this product with a damaged collection bag (5) or without
one at all!
Connection to power supply
For safety reasons the product is equipped with a short power cord (9). Do not
connect the product directly to the power supply using this power cord. A proper
extension cord is required for operation. Observe the technical requirements for
this product when purchasing an extension cord.
NOTE: For your safety, it is required that the plug attached to this
product is always connected to an extension cord! The extension cord
must be suitable for outdoor use with sockets protected against water
splashing! Ensure the extension cord is of the proper size and type for
your product (≥ 1.5 mm²)!
Always use a residual current supply (RCD) protected supply.
1. Double the extension cord back, about 30 cm
from the end and lead the loop through the slots
of cord retainer (10) (Fig. 4).
2. Pull it over the hook of cord retainer (10) and
gently tug on the cord to ensure that it is rmly
secured (Fig. 5).
3. Connect the power cord (9) to the socket of the
extension cord (Fig. 6).
4. Make sure the on/off switch (7) is not stayed at
ON position.
10
1.
Fig. 4
2.
10
Fig. 5
5. Connect the plug of extension
cord into a suitable socket.
9
Fig. 6
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 17MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 17 2022/3/21 5:46 PM2022/3/21 5:46 PM
To Next Page
Loading...
