EN
32
In
more
detail...
MLM1841
by MacAllister
Troubleshooting
Troubleshooting
Problem Possible cause Solution
1. Product does
not start
1.1. Not connected to power
supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect to
the product
1.1. Connect to power supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e.g.
generator) has too low
voltage
2.3. Air vents are blocked
2.1. Use a proper extension
cord
2.2. Connect to another power
source
2.3. Clean the air vents
3. Cutting
result is
unsatisfactory
3.1. Cutting blade is dull /
damaged
3.2. Cutting material exceeds
capacity
3.3. Cutting height is incorrect
3.1. Replace with a new one
3.2. Only cut materials
according to the product
capacity.
3.3. Adjust the cutting height
4. Product
suddenly
stops
4.1. Cutting device is dull /
damaged
4.2. Cutting device is blocked
4.1. Replace with a new one
4.2. Remove blockage
5. Excessive
vibration or
noise
5.1. Cutting device is dull/
damaged
5.2. Cutting material exceeds
capacity
5.3. Cutting height is
incorrect
5.4. Bolts/nuts are loosen
5.1. Replace with a new one
5.2. Only cut materials
according to the product
capacity
5.3. Adjust the cutting
height
5.4. Tighten bolts/nuts
To Next Page
Loading...
