14
Your product
1. Handle (with gripping surface) 21
2. Brake bar 22 Cord clip
3. Drive bar 23 Electric cord
4. Upper handle bar 24 START button / key
5. Brake wire 25 Rear discharge chute
6. Drive wire 26 Oil drain screw
7. Lower handle bar 27 Cutting device (blade)
a. Handle support (left & right)* a. Spindle
b. Bolt* b. Pin
c. Nut* c. Ring
d. Washer* d. Support
e. Spring washer*
8. Mounting set (x 2) f. Hex bolt
a. Fixing knob* 28 Mulching insert
b. Bolt* a. Unlock button
c. Spacer* 29 Side discharge attachment
9. Wire clip 30 Charger
10. Air vents a. Power cord with plug
11. Fuel tank b. Sliding slots
a. Cap c. Air vents
12. d. Charging status indicator
13. Wheel (RED / GREEN)
14. Spark plug connector 31 Battery pack
a. Spark plug* a. Release button (x 2)
15. b. Battery capacity indicators
16.
c. Battery capacity button
a. Locking buckle* 32 Spark plug wrench
17. Battery docking port 33 Briggs & Stratton (B&S) operator´s manual*
18. Oil tank cap
19. Lever for cutting height adjustment
20. Grass catcher
a. Handle
b. Hatch
c. Hook*
d. Rod*
15
NOTE: Parts marked with * are not shown in this
overview. Please refer to the respective section in the
instruction manual.
General
Dimensions approx. 1420x550x1010
Machine mass with empty tanks and in normal
approx. 31.1kg
Fuel tank capacity 800ml (cm
3
)
Petrol type unleaded
Engine oil capacity 470ml (cm
3
)
Engine oil type 4-stroke engine oil(e.g. SAE10W-30)
371g/kWh
Fuel consumption at max. engine power 0.89kg/h
Cutting device thickness 4mm
Cutting width 46 cm
Cutting height 25-75mm
Grass catcher volume 60L
Engine
Engine model B&S 575iS
Engine type air cooled, 4-stroke engine
Engine displacement 150 cm
3
Rated engine speed 2800 min
-1
Maximum operating engine speed (rotational frequency) 3600 min
-1
Nominal power 2.2 kW
Spark plug type XC92YC
Spark plug gap 0.7 – 0.8 mm
Carburettor 596779
Battery pack
Model no. IS12B
Type Li-Ion
Capacity 1150 mAh
Voltage 10.8 V
Weight approx. 0.29 kg
Charger
Model no. IS12C
Rated input voltage, frequency 100 - 240 V~, 50-60 Hz
Rated input current 0.8 A
To Next Page
Loading...
