MAC Audio SOUNDBAR 550

16
CONNECT AND SET UP
This section helps you connect your Soundbar
to a TV and other devices, and then set it up.
Note
• For identification and supply ratings, see
the type plate at the back or bottom of the
product.
• Before you make or change any connections,
make sure that all devices are disconnected
from the power outlet.
Wall mount the Soundbar (optional)
Screw length/diameter
Depending on the type of wall for mounting
your Soundbar, make sure that you use screws
of a suitable length and diameter.
1. Drill two holes on the wall (distance 40cm).
2. Secure the dowels and screws in the holes.
3. Hang the Soundbar on the fastening screws.
Warning
• Improper wall mounting may result in
accident, injury or damage. If you have
any query, contact Consumer Care in your
country.
• Before wall mounting, make sure the wall
can support the weight of your Soundbar.
• Mac Audio is not liable for improper wall
mounting that results in accident, injury or
damage.
• Install the Soundbar on a sturdy vertical
wall.
• Do not install the Soundbar onto a ceiling or
slanted wall. It may fall down and result in
severe injury.
• Do not mount the Soundbar on a wall while
the Soundbar is plugged in or turned on, it
may result in an electrical shock injury.
CONNECTIONS
Connect to TV
Connect your Soundbar to a TV through a
line in cable. You can listen to audio from TV
programs through your Soundbar.
Note
During play, do not plug out the line in cable.
On your TV, it is recommended to set the
volume in the range of 60% maximum volume
to avoid distortion of the audio output.
If your TV supports OPTICAL OUT feature,
connect your Soundbar to the TV through a
digital optical cable (not supplied).
Connect audio from other devices
Play audio from other devices through your
Soundbar speakers.
Note
During play, do not plug out the audio cable.