MAC TOOLS MPF970501 - Technical Data

15
ENGLISH
6.35 mm NPT
High Flow Fitting
Air Hose
10mm
I.D. Min
MPF970501 MPF972501
Square drive in / mm .5 / 13 .5 / 13
Impact Rate
bpm
fwd / rev
1030 / 1120 1010 / 1060
Breakaway torque ft‑lbs / Nm 1100 / 1490 1100 / 1490
Noise Level Pressure
(ISO 15744)
dB(A) 90 / 3* 90 / 3*
Noise LevelPower
(ISO 15744)
dB(A) 101 / 3* 101 / 3*
Vibration level
(ISO 28927‑2 )
m/s
2
5.2 / 1.5** 5.2 / 1.5**
Average air
consumption
cfm / I/min 5.2 / 147.2 5.2 / 147.2
Working pressure psi / bar 90 / 6.2 90 / 6.2
Weight lbs / kg 6.2 / 2.8 6.4 / 2.9
Dimensions in / mm
7.5 X 2.8 X 7.6 /
190 X 70 X 193
9.6 X 2.8 X 7.6 /
243 X 70 X 193
* = measurement uncertainty in dB(A)
** = measurement uncertainty in m/s
2
EC-Declaration of Conformity
Machinery Directive
1/2" AIR IMPACT WRENCH
MPF970501, MPF972501
MACTOOLS declares that these products described under
Technical Data are in compliance with: ISO 11148-6:2012.
These products also comply with Directive 2006/42/EU. For
more information, please contact MACTOOLS at the following
address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf ofMACTOOLS.
Markus Rompel
Vice-President Engineering, PTE-Europe
MACTOOLS, Egide Walschaertsstraat 14-18
2800Mechelen, Belgium
09.08.2021
DECLARATION OF CONFORMITY
THE SUPPLY OF MACHINERY SAFETY
REGULATIONS 2008
1/2" AIR IMPACT WRENCH
MPF970501, MPF972501,
MACTOOLS declares that these products described under
Technical Data are in compliancewith:
The Supply of Machinery (Safety) Regulations, 2008, S.I.
2008/1597 (as amended),
ISO 11148-6:2012.
For more information, please contact MACTOOLS at the
following address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of MACTOOLS.
Karl Evans
Vice President Professional Power Tools EANZ GTS
MACTOOLS UK, 270Bath Road, Slough
SL1 4DX
England
09.08.2021
The Mac Tools™ MPF970501 and MPF972501 are precision-built
tools, designed for driving, tightening and loosening threaded
fasteners, usually nuts and bolts, when fitted with a suitable
impact socket. These tools will deliver efficient, dependable
service when used correctly and with care. As with any
fine power tool, for best performance the manufacturer’s
instructions must be followed. Please study this manual before
operating the tool and understand the safety warnings and
instructions. The instructions on installation, operation and
maintenance should be read carefully, and the manual kept for
reference. NOTE: Additional safety measures may be required
because of your particular application of the tool. Contact your
Mac Tools representative or distributor with any questions
concerning the tool and itsuse.
Technical Data
English (original instructions)
1/2" AIR IMPACT WRENCH
MPF970501, MPF972501