14
MCS2400 by MacAllister
In more detail...
GB
IE
Product functions
Intended use
This chain saw MCS2400 is designated with a rated input of 2400
Watts. The product is intended for cutting logs with a thickness of
max. 435 mm. It must not be used for cutting other materials, such
as plastic, stone, metal or wood that contains foreign objects.
The product may only be used with the guide bar/saw chain
combination stated in these instructions. It is not permitted to use
other types or sizes.
Vertical and horizontal cuts can be performed with this product.
Longitudinal sections can only be cut by professionals.
This product should not be used outside of domestic premises e.g.
for cutting rewood in forested areas.
The product should not be used on masonry and materials that are
harmful to health.
This product is intended for private domestic use only, not for any
commercial trade use. It must not be used for any purposes other
than those described.
The overload protection may be activated in the following
circumstances:
If you work too quickly. >
Heavy cutting conditions. >
Where there is too much resistance against the cutting device. >
When the circuit breaker has been activated switch off the product
and disconnect from the power supply. Let the product cool down
for 2-3 minutes and eliminate the cause before using the product
again. Press the reset button (15), connect the product to power
supply, and re-start your product (Fig. 14).
15
Fig. 14
Overload protection
To Next Page
Loading...
