24
WARNING! Before switching the tile cutter on, make sure that you
have read and understood all of the safety instructions. Make sure
also that the machine has been correctly assembled and adjusted.
Make sure that the mains is disconnected from the supply when
the tile cutter is not being used, or adjustments are being made.
WARNING! This machine must be supplied through a residual
current device (RCD).
NOTE: Product damage!
Carefully check the workpiece to be machined. Foreign bodies
such as nails, screws or similar can seriously damage the product.
NOTE: Product damage!
The product is not suitable for cutting materials such as marble,
fine stoneware and granite. Tile floor made up of these materials
must not be cut.
NOTE: Product damage!
Wait until the cutting disc has reached its maximum speed before
commencing work.
NOTE: Product damage!
Before commencing work, check there is sufficient cooling water
in the product.
NOTE: In the case of complex cuts (mitre or jolly) we recommend
making a test cut beforehand.
WARNING! Risk of injury!
Maintain an adequate distance from the cutting disc when cutting.
WARNING! Risk of injury!
Do not reach into the working range of the spinning cutting disc
while the product is operating.
MTC650 by MacAllister
Product functions
In more detail…
EN
To Next Page
Loading...