After the installation, you will get USB2.0 Hi-Speed performance, if PHR-
100ACE is connected to USB2.0 host adapter; if connected to USB1.1 port
in your computer, you will get USB1.1 speed only.
Note: If you don’t see the new drive letter added in My Computer after
driver is loaded properly, the reason could be the hard disk has no par-
tition and format yet, please partition and format the drive in the enclo-
sure before using it.
IDE Hard Drive Partition and Format procedures in PC:
For Windows98SE/ME
If a new hard disk icon dose not appear in “My Computer”, check device
manager under system in the control panel. Then double click on
“Disk Drives” to see if a new entry appears.
If you can see a new entry as shown (Example, WDC WD80 OBB-32BSA0)
above, you are ready to partition and format the drive.
17
To Next Page
Loading...