Mach M20.06 - Moving about the Screens; Operation; Utilities Menu

14 Operation
O PERATION 5
The chapter describes:
• “Moving about the screens”
• “Utilities menu”
• “Inputs menu” on page 17
• “Outputs menu” on page 17
• “EQ screens” on page 20
• “Store and recall” on page 21
After powering up, the unit performs internal checks and sets up the audio
path before releasing the output mute relays. This takes a few seconds.
When the unit is powered up the Default Screen is shown. This shows the
current program name and number.
MOVING ABOUT THE SCREENS
Use the:
• UP/DOWN access keys to move between Default, Utility, Input and Output menus
(Horizontal columns).
• RIGHT and LEFT keys to move along each menu.
• Parameter UP/DOWN keys to adjust a parameter. (When adjusting a value,
pressing a key once will usually give a small increment/decrement whilst holding a
key down will give a larger increment/decrement).
Moving to a new menu may not bring up the first screen shown in each row,
as the unit remembers, and moves you to, the last screen accessed in each
menu.
Store and Recall are accessed by pressing their respective keys.
UTILITIES MENU
Pushing the RIGHT key while viewing the default screen will move you into
the Utilities menu. The RIGHT and LEFT keys are used to move along the