22
Operation
UNLOCKED?, asking whether the program should be stored with a Program
lock on/off. Use the Parameter UP/DOWN keys to turn the Lock on/off, the
default setting being ON. Once the Lock status is set, push the STORE key
a final time to commit the program to memory. The display will now default
back to the screen displayed before the STORE facility was accessed. To
exit from the store screen without storing a program, press the RECALL
button.
Recalling
Pressing the RECALL key will access the Recall screen. This facility is
displayed in the same way as the store facility.
The Parameter UP/DOWN keys are used to select the program number to
recall (when highlighted). When the program you wish to recall has been
selected, push the RECALL key again to recall the program. The unit will
display a message showing that data is being recalled, and will then display
the default screen once the recall is complete.
To exit from the recall screen without recalling a program, press the store
button.
To Next Page
Loading...