44
04.07.2014
To create and manage user defined methods one can also use the free-of-charge
NANOCOLOR
®
data export software from MACHEREY-NAGEL. This can be downloaded
via www.mn-net.com/PF-12Plus. Further information can be found in the software manuals
under the same link.
7.2 Sample numbering
To differentiate between samples, the PF-12
Plus
assigns a sample number to every measure-
ment (starting with 0001). Subsequent measurements are numbered accordingly. You have
the option to change the sample number after every measurement and to assign it to the
current result. To do so, press
before the next measurement. An entry option appears to
enter the 4 digit sample number via the keypad. Once you have entered the sample number,
it is displayed together with all other sample information at the bottom of the display. The
following measurements are then automatically numbered. The sample numbering is carried
out on the basis of a daily counter. With each new day the PF-12
Plus
starts to count with the
sample number 0001 and counts upwards for each further measurement.
7.3 Identification of sample location
To differentiate between sampling locations, you have the option to enter a sample location
after performing a measurement (up to 12 characters). Press button
to open the entry
option for the sample location. Once you have entered the sample location, it is displayed
together with all other sample information at the bottom of the display. The sample location
is added to the result in the memory automatically. If you have entered additional sample
locations before, you can press
to choose or edit the sample location from a list of up to
20 previously defined sample locations with the buttons
/ . For editing the sample plac-
es choose the appropriate entry with the
/ buttons and replace the existing
letters with
the keypad. Deleting single digits can be accomplished by typing the button “1” two times.
To Next Page
Loading...
