10
4.3 Wifi repeater configuration
a. Login the Web management page, click “ Repeater Mode”, then “Scan AP”
b. Select the AP’s SSID want to bridge, take SR800-2.4G for example.
c. input the AP’s key, and apply changes
d. In Repeater Mode, the SSID is disable in default setting, it work as Station;if need SSID broadcast in this mode, just manual to
change under Advanced Settings,click sure in this part to finish the repeater operation mode setting After this step, can click the
Device status to check the status of this Wireless AP. And it will show Wireless AP’s LAN Interface, WLAN status and Sigbal Strength.
To Next Page
Loading...
Need help?
General